E-Trac Lite
E-Trac Lite is a complete engineered overhead conveyor product line designed for lighter duty applications. This product line can be utilized for manual hand pushed systems or powered systems and will provide many years of service. E-Trac Lite equipment is ideal for but certainly not limited to tool rails, light duty paint finishing systems, fruit packing systems, empty box and tote systems, as well as custom production, process and assembly lines. Please contact 1stSource for application or technical assistance at 812-406-2092.
-
E-Trac Lite Chain & Track
The E-Trac Lite Conveyor Chain is a high tensile, heat-treated, semi-precision roller bearing chain. -
E-Trac Lite Track Components
E-Trac Lite Inspection Section, Track Hanger, Welding Sleeve and Oven Expansion. -
Track Horizontal Curves
Curves are fabricated from 1-5/8" O.D. x 1-3/8" I.D. steel tubing and heat treated to withstand normal wear. -
Track Top and Bottom Vertical Curves
Top and bottom curves will work with either inside or outside slot position. It is critical to make sure slots are aligned and are at correct locations.
-
Take-Up Units
A Take-Up unit is required on all E-Trac Lite systems and must be located downstream from, and as close as possible to, the drive. -
180 Degree Sprocket Turn - Screw Take-up
Take-Up Idler Sprocket Turns are used on systems less than 150 ft. in length and where a small radius turn is required. These units are especially useful where a turn or Take-Up is located in and oven. The Take-Up Idler Sprocket Turn provides 4 inch of travel. -
Horizontal Idler Sprocket Turns
Idler Sprocket Turns are used for extremely short radius turns. The Idler Sprocket Turns are fabricated with graphite impregnated bronze bearings with a rating of 450 degree F. -
Drive Units
Position of drive determines the slot location for the entire system. Drives include 1/4 or 2 HP TEFC Inverter Duty Integral Mount or optional C-Face motor, parallel helical gear reducer, drive sprocket, power tubes and mounting plate.
-
Carriers
Load bar carriers are designed to allow the E-Trac Lite system to convey individual loads up to 120 lbs. Rotating Carrier: When installed with a rub rail, the turning action is continuous during contact. NOTE: For special load bars, carriers and document handling attachments, please contact 1stSource at (877) 338-9403 ext. 112. -
Hand Pushed 4 Wheel Trolley
This is a trolley that is manually pushed through the conveyor track. It is ideally suited for operations where a powered conveyor is not needed. Capacity: 120 lbs. -
E-Trac Lite Conveyor Lubricators
Requires field assembly. Squirts measured shots of lubricant into chain wheels and universal joints while conveyor is running. Reduces downtime and manual labor in lubricating trolleys. Eliminates surging caused by non-lubricated and worn conveyor.