The chain must be properly lubricated to ensure correct operation and chain life. An automatic lubricator is required on all systems. The automatic brush type solenoid-operated lubricator is attached to a 14" section of straight track which can be welded to any section of straight run in the system. The brush protrudes through a slot cut in the track. An adjustable screw regulates the amount of oil flow. Electrical connections can be attached to the motor leads, starter control circuit, a switch, or a timer, depending on requirements of the system. Lubricators are available for 110 volt, 230 volt, 460 volt or 208 volt connections. A lubricator should be installed on the outlet side of each oven, washer, dryer and de-greaser. When used with an oven, it should be located sufficiently far from the outlet so that the chain is not too hot to the touch. In some applications, such as paint lines or systems with special washers, ovens and processing equipment, the use of brush oiler's may not be appropriate. An automatic lubricator with lube designed specifically for these types of applications may need to be used. For further information, please contact your 1stSource Products representative.