E-TRAC LITE TRACK TOP and BOTTOM VERTICAL CURVES
Curves are fabricated from 1-5/8" O.D. x 1-3/8" I.D. steel tubing and heat treated to withstand normal wear. Vertical curves are available in 16" radius curves only. All curves are available in the following stock degrees:
- 15°
- 45°
- 60°
- 90°
- 180°
Intermediate degrees are available upon request.
The 16” radius curves are recommended in most applications.
-
Top Vertical Curves
Top Vertical Curves will work with either inside or outside slot position. It is critical to make sure slots are aligned and are at correct locations. -
Bottom Vertical Curves
Bottom Vertical Curves will work with either inside or outside slot position. It is critical to make sure slots are aligned and are at correct locations.